Griaule Biometrics

This Quick Start Guide is intended to help you through your first installation of REX2006 software and hardware. It is assumed that your REX has the factory defaults.

1. Run the REX2006 Installer and install the SDK, the REX Identity application or both;
2. If there is no DHCP server on your network for REX to get an IP address from, you will need to change your IP address to 192.168.0.201;

3. Run any of the REX2006 samples or the REX Identity application;
4. Make sure REX is powered off and plug a network cable on REX board;

5. Plug the power cord on REX board and turn it on;

6. After a few seconds REX shall connect to the running sample or to the REX Identity application.